Cupra 2.0 TFSi Cat Back System - WRC SOUND
Tags: seat leon cupra 2.0 tfsi fr, cat back system, tfsi, trim
Cupra 2.0 TFSi Cat Back System - WRC SOUND
Available Options
Due to the uniqueness of our products and the way in which they are manufactured, there may at times be a production delay of up to 2 weeks from the initial purchase date.
The BCS Valveless Cat-back WRC exhaust is our loudest option for the Seat Leon Cupra 2.0 TFSi, providing you with the maximum possible full-time audible thrill from your Cupra.
The system has been carefully designed to ensure that any unwanted in-car frequencies have been removed, leaving you with a full-on drone-free experience, together with our characterful pop and burble, free-revving sound.
The primary use for the WRC variant system is the track or closed/private road.
As with virtually all of the TFSi engined vehicles, there is very little performance gain to be had from the cat-back system on its own, due to the incredibly restrictive downpipe and twin OEM cats.
If you require more power from your Cupra we recommend the 76mm (up to 400 bhp) or 90mm (400 bhp+) downpipe to go with this system.
Coating Specification
Formulated to withstand temperatures of over 1050°c and thermal shock from those temperatures directly into water with no adverse effects
Gloss Level | 5.0 Gloss Units at 60° |
Theoretical Solids by Weight | 75% +/- 2% |
Viscosity (Brookfield Viscometer) | 120-290 cP* |
5% Salt Spray (ASTM B117) | 1000+ hours |
Pencil Hardness (ASTM D3363) | 9h |
Scratch Hardness (ASTM D3363) | 9h |
Adhesion Cross-Cut Tape (ASTM D3359) | 5B |
Mandrel Bend (ASTM D522) | 2 mm coating loss at 180° rotation |
Impact (ASTM D2794) | 72/20 inch-lbs |
Hot Adhesion | Excellent |
Abrasion Resistance (ASTM D4060) | 1203.33 wear cycles per mil |
Density (g/ml) | 1.15 |
As the original rubber mount for the center silencer is prone to wear in regards to its ability to support and prevent excessive movement, we recommend its replacement with the upgraded VAG rubber as shown below.
Please note that our system includes a front section which joins the OEM cat closer to the engine than other brands. You will, therefore, need to cut your down pipe just after the cat to enable our system to fit as can be seen in the images.